BLF(Broadworks) Icons Issue on T48G

[hari908]

Please find my answers inline. Attached the syslog, pcap and config in yealink_TP48G.zip

Scenario Tested:
1. Yealink(1647) monitors BLF Line 1648.
2. 1649 calls 1648. 1648 answers and establishes call with 1649.
3. After few seconds, 1649 ends the call.

(09-10-2014 04:54 PM)Yealink_James Wrote:  Hi Hari908,

What's your phone firmware?
>> 35.72.193.10

The BLF status depends on the NOTIFY message sent by sip server. If phone receive a NOTIFY message which tell phone change to BLF status to idle, it shouldn't remain in ringing state.
Is the T48G in a same network to Polycom phones?
>>> Both are connected to the same POE switch.

If possible can you get a pcap file and level 6 syslog in the process? We will check whether phone receive a Notify message when ending a call.

>> Attached the syslog, pcap and config in yealink_TP48G.zip

For how to get a pcap file and syslog:
http://forum.yealink.com/forum/showthread.php?tid=1319

Regards,
James