T46G: Power LED always flashing when backlight is off

[Travis_Yealink]

(10-09-2017 01:49 PM)Werner1959 Wrote:  Now I understand, why it worked on my device at once after the update to V82:

These two parameters

features.power_saving.power_led_flash.on_time = 0
features.power_saving.power_led_flash.off_time = 100

were part of the special firmware 81.*.91. Therefore these two values also automatically were part of my saved configuration. After the update with V82 and after reloading the saved configuration into the device these two parameters were back in the device again, although they are - different to special firmware 81.*.91 - not editable on web interface in V82.

Hi Werner,

Exactly, you are correct.
In V82 firmware, we don't have web interface, but the parameters are still the same as "special firmware" I provided.

Best Regards,
Yealink_Travis

[Petecat1]

I am also trying to fix this problem. The issue I have is when trying to import the new Auto Provisioning Template via TFTP server (3cdaemon),

The server gives an error: Could not open requested file for reading
Wireshark tells me (I don't have it in front of me right now) that there was an access violation.

I am guessing that this has something to do with permissions or certificates I have set "Only Accept Trusted Certificates" to Disabled.


Any tips on getting past this? I would love to stop that flashing light!

[SimpleCom]

I just upgraded my T46G to 28.83.0.50. I don't see where I can disable that stupid little blinking light. Anyone got a tip on this?

[Who]

Hi,

you could do manual provisioning of the properties:

features.power_saving.power_led_flash.on_time = 0
features.power_saving.power_led_flash.off_time = 100

Backup your config, add the two lines to your config and restore it afterwards.

There are no items in the webgui to set these properties.

BR
wkn

[SimpleCom]

Nothing in the web gui. Okay, so the next question is how to get to the settings you indicate? I'm sorry that I don't have that knowledge.

[Who]

- In webgui go to Settings / Configuration
- Export the CFG with all settings
- Edit the file and add the two lines
- Import the saved file again