T46G weekly provision problem

[engine411]

Here is my config for this auto provision. What I want is for the phone to reprovision each week on Thursday between 10:40 and 11:05 after it's inactive for 2 minutes. Are these settings correct to accomplish that?

auto_provision.weekly.enable = 1
auto_provision.weekly.dayofweek =
auto_provision.weekly_upgrade_interval = 0
auto_provision.inactivity_time_expire = 2

#Configure the start time of the day for the phone to check new configuration files. The default value is 00:00.
#It is only applicable to "Weekly" and "Power on + Weekly" modes.
#If the desired start time of the day is seven forty-five a.m., the value format is 07:45.
auto_provision.weekly.begin_time = 10:40


#Configure the end time of the day for the phone to check new configuration files. The default time is 00:00.
#It is only applicable to "Weekly" and "Power on + Weekly" modes.
#If the desired end time of the day is seven forty-five p.m., the value format is 19:45.
auto_provision.weekly.end_time = 11:05

#Configure the day of week for the phone to check new configuration files. The default vaule is 0123456.
#0-Sunday,1-Monday,2-Tuesday,3-Wednesday,4-Thursday,5-Friday,6-Saturday;
#It is only applicable to "Weekly" and "Power on + Weekly" modes.
#If the desired week is Monday, Tuesday and Wednesday, the value format is 012.
auto_provision.weekly.mask = 4

---

(10-26-2017 03:00 PM)complex1 Wrote:  

(10-26-2017 02:32 PM)engine411 Wrote:  @complex1, that is a good point in the right direction, thank you. What is the meaning of this setting and its value: Weekly Upgrade Interval(0~12week)

I think it means "every x weeks", but what is the difference between a value of 0 and 1? Which value means "every week"?

Hi,

The difference between a value of 0 and 1 is if it is set to 0 or 1, the IP phone will perform an auto provisioning process every other week.
Do you want to perform an auto provisioning every week, then use the value 2~12

Hope this will help.

That doesn't make sense to me, but that's been the case before with Yealink settings that worked when I tried them. I'll try it. Thanks.