T48G Incoming Transfer Ring Question

[Jensen_Yealink]

(08-07-2018 11:16 PM)mike366 Wrote:  May apply to other phones, not sure, but is an issue on t48g:

T48G, rings on first blind transfer from another phone, 2nd simultaneous blind transfer, while she is still on the t48g with the first transfer, does not ring on t48g, just scrolls a note that there is an incoming transfer. How do I make it ring on all transfers to the t48g, so it is more obvious to the t48g user that a transferred call is coming in to her phone, evenif she is already on a call?

---

So if this actually happened, where do I set it (phone does have call waiting enabled, and call waiting tone is enabled, but she says she does not hear any tone, and wants RING anyway):
Firmware is: 35.83.0.35

http://forum.yealink.com/forum/archive/i...-3100.html
James_Yealink
01-07-2015, 06:48 AM
Hi,

Finally the feature is accepted by our product department and it will be desinged in V81 firmware.(Since the V80 is not desgined as "feature adding" firmware)

According to the design it seems that there will be three options, call waiting tone, ring, silent.

Regards,
James

---

(08-07-2018 11:16 PM)mike366 Wrote:  May apply to other phones, not sure, but is an issue on t48g, but all incoming calls ring on the T54S, but I don't see any differences in the web interface to each phone:

T48G, rings on first blind transfer from another phone, 2nd simultaneous blind transfer, while she is still on the t48g with the first transfer, does not ring on t48g, just scrolls a note that there is an incoming transfer. How do I make it ring on all transfers to the t48g, so it is more obvious to the t48g user that a transferred call is coming in to her phone, evenif she is already on a call?

---

So if this actually happened, where do I set it (phone does have call waiting enabled, and call waiting tone is enabled, but she says she does not hear any tone, and wants RING anyway):
Firmware is: 35.83.0.35

http://forum.yealink.com/forum/archive/i...-3100.html
James_Yealink
01-07-2015, 06:48 AM
Hi,

Finally the feature is accepted by our product department and it will be desinged in V81 firmware.(Since the V80 is not desgined as "feature adding" firmware)

According to the design it seems that there will be three options, call waiting tone, ring, silent.

Regards,
James

Dear Customer,

I make a testing on my side, the T48G works well while second transfer incoming call: there beep tone. Please upgrade to below firmware and testing:
https://drive.google.com/open?id=17e_8OK...86k12lK1eO

If still have issue, please provided the PCAP, config.bin and syslog with level 6:
http://support.yealink.com/faq/faqInfo?id=707

BR
Jensen