EDK Macro Help

[gyegavian]

I know this post is a bit old however I was able to do something similar by using $Trefer$ instead it $Tinvite$

edk.edklist.1.action = $KSoftKey1$*125$PEnter Ext&C10&N&M$$Trefer$
edk.edklist.1.enable = 1
edk.edklist.1.mname = test

edk.edkprompt.1.enable = 1
edk.edkprompt.1.label = Enter Ext
edk.edkprompt.1.type = numeric
edk.edkprompt.1.userfeedback = visible

softkey.1.enable = 1
softkey.1.label = Park
softkey.1.position = 1
softkey.1.action = #700#$Tdtmf$
softkey.1.softkey_id = Park
softkey.1.use.idle = 0
softkey.1.use.dialtone = 0
softkey.1.use.on_talk = 1
softkey.2.enable = 1
softkey.2.label = Hold
softkey.2.position = 1
softkey.2.action = $Shold$
softkey.2.use.idle = 0
softkey.2.use.dialtone = 0
softkey.2.use.on_talk = 1
softkey.3.enable = 1
softkey.3.label = EndCall
softkey.3.position = 1
softkey.3.action = $Sendcall$
softkey.3.use.idle = 0
softkey.3.use.dialtone = 0
softkey.3.use.on_talk = 1
softkey.4.enable = 1
softkey.4.label = VMXfer
softkey.4.position = 4
softkey.4.action = !test
softkey.4.use.idle = 0
softkey.4.use.dialtone = 0
softkey.4.use.on_talk = 1
softkey.5.enable = 1
softkey.5.label =
softkey.5.position = 5
softkey.5.action =
softkey.5.use.idle = 0
softkey.5.use.dialtone = 0
softkey.5.use.on_talk = 1
softkey.6.enable = 1
softkey.6.label =
softkey.6.position = 4
softkey.6.action =
softkey.6.use.idle = 0
softkey.6.use.dialtone = 0
softkey.6.use.on_talk = 1

(03-12-2018 11:22 PM)Oregon Wrote:  Hi,

I can't seem to figure this one out and would appreciate some help. New to Yealink phones as well. Here is the only thing I can't figure out how to do.

On an active call, I would like a softkey (labled VMXFER) to appear. When pressed, it would initiate a transfer and already know (macro perhaps?) to insert a 7, then do an EDK prompt to ask the user "Enter Ext". The user would enter an extension number, then press SEND which would then send 7+ext input to the PBX.

This button is to transfer a call directly to voicemail on a Netsapiens switch (Transfer 7+ext). I'm testing with a T52s on firmware 70.82.0.36.

Thanks!