Problem with Yealink T46G Audio Settings

[Heiko]

Hi i am using a 3CX PBX v15.5

Yealink T46G firmware version 28.81.0.61.
 
I want to auto provisioning the T46G with the following parameter:
 
 
Headset Send Volume (-50~50)
 
Description:
 
It configures the sending volume of the headset.
 
CFG Configuration:
 
voice.headset_send
 
Valid Value:
 
(Integer from -50 to 50)
 
 
Handset Send Volume (-50~50)
 
Description:
 
It configures the sending volume of the handset.
 
CFG Configuration:
 
voice.handset_send
 
Valid Value:
 
(Integer from -50 to 50)
 
 
Handfree Send Volume (-50~50)
 
Description:
 
It configures the sending volume of the speaker.
 
CFG Configuration:
 
voice.handfree_send
 
Valid Value:
 
(Integer from -50 to 50)
 
 
And it dont work. The phones dont take the settings.

[WolfgangOne]

I found this recently, too, after a 3CX update. I eventually fixed it by moving the entire voice section down in the template, after:
]]></deviceconfig>
</device>
</data>
<data>
<device>
<type>phone</type>
<!-- Friendly Name -->
<field name="Name">Yealink T4x Identity</field>
<deviceconfig filename="%%mac_address%%.cfg"><![CDATA[#!version:1.0.0.1

and before the Network section. For some reason, the settings above this point seemingly weren't actually being parsed by 3CX at all, it seems.

[anonymous1715066757752]

(07-21-2017 03:13 PM)WolfgangOne Wrote:  I found this recently, too, after a 3CX update. I eventually fixed it by moving the entire voice section down in the template, after:
]]></deviceconfig>
</device>
</data>
<data>
<device>
<type>phone</type>
<!-- Friendly Name -->
<field name="Name">Yealink T4x Identity</field>
<deviceconfig filename="%%mac_address%%.cfg"><![CDATA[#!version:1.0.0.1

and before the Network section. For some reason, the settings above this point seemingly weren't actually being parsed by 3CX at all, it seems.

Dear Customer，
Do you mean you fix this issue,via moving the entire voice section down in the template, after:
]]></deviceconfig>
</device>
</data>
<data>
<device>
<type>phone</type>
<!-- Friendly Name -->
<field name="Name">Yealink T4x Identity</field>
<deviceconfig filename="%%mac_address%%.cfg"><![CDATA[#!version:1.0.0.1

BR
Paul

[WolfgangOne]

Yes, that is what fixed the issue for us. The Yealink phones now successfully respect my settings about handset send volume and such after moving that code.

Before moving the code, if you go in 3CX to Phones -> highlight the extension -> click the +Config button, it will display a preview of the actual, filled-out config that is passed to the phone. This is how I worked this out - the Voice section, including "voice.headset_send = 20" and the like, were NOT visible in that preview of the config. I worked out where the code appeared to start from, which is just after that excerpt. So I just cut and pasted the entire voice settings block after that, and voila! Previewing the config, you can see it start with the voice settings.