T48 DSS Key Overlay

[brandywine]

I have 2 buttons configured ,

1 is a BLF for a group ring , and the other is a Prefix for *87 to grab that group if its ringing ,

if I see the group ring and no one picks up , I can press the Prefix button and it goes to the key pad to dial the group ext ,

this works but if I want to use just 2 keys to press 1 for the Prefix and then the second for the BLF for the group , I have to press the DSS Key as a 3rd key to switch back to the DSS as the screen doesn't stay there ,

is there a setting to suppress the keypad and stay on the DSS mode so I can simply press the <pickup> button and then the <BLF> button without having to toggle back to the DSS screen ,

[Elaine_Yealink]

Dear,

I think there is an easier way to achieve your request. We can configure the BLF key to pick up the incoming call.
Take attached picture as an example:
1. Account 1 3002 registered.
2. In the DSSkey configuration, select BLF as type and fill in the 3001(you can fill in your ring group number), in the last field, fill in *20*(*89 in your case).
3. In this way, if 3001 has an incoming call, the DSSkey will flush red. Then you can press the key to pick up the call.

Give it a try.
Regards
Elaine