Ringing on second call - 3CX

[James_Yealink]

Hi Don,

OK, we have confirmed that the feature will be added in V81. So now please just wait V80 and then V81. If get the time frame of V81
I will let you know.

Regards,
James

[Fez]

We're going to be deploying 3CX in a similar set up and will need this feature too. Will this thread be updated when V81 is confirmed to offer this option and be available?

[A.BVComm]

After upgraded to V80 or V81, do we have to program something or it's already programmed and should ring on second incoming call?

[James_Yealink]

Hello, there will be an option in V81 firmware. You should configure it.

[jasril]

(11-17-2015 03:02 PM)wujs Wrote:  Hello, there will be an option in V81 firmware. You should configure it.

havent been able to find this feature, where is it documented?

[Rory]

Has this feature been added to v81? If so could someone tell me the CFG Configuration line please.

[AIR Technology Services]

I reached out to Support pointing them to this thread and they said:
"Now V81 didn't add this feature. So now we can only change the frequency of call waiting, please see attached guide. In phone webUI path: webUI>>settings>>tones>>call waiting"

[Chris Barron]

I have a workaround fix for this, as follows.

Register a second line to the phone, to illustrate, label it "overflow'

Turn off call waiting on the first line and allow secondary calls to route to the overflow line (Divert/ring group/group hunt)

Rather than configure the second line with its own key, configure it as BLF with ring.