Phone provisioning: Display message on screen

[KNERD]

A while back I was researching on how to get a message on the phone from the server side to the phone. While researching this, I had come across the method I need to really use before even knowing it.

I had run into an example where one could use provisioning to display a message on the telephone LCD screen.

I cannot find this example again, and I have looked in the documentation on provisioning without luck.

Any ideas on this?

Thanks.

[Lucia_Yealink]

HI Sir，

You can use XML broswer feature to achieve your requirement. Please download the guide and template file in the link below:

http://download.support.yealink.com/down...V81_20.pdf

http://download.support.yealink.com/down...V81_20.zip

Best Regards,
Lucia

[KNERD]

(12-05-2016 12:15 PM)Lucia Wrote:  HI Sir，

You can use XML broswer feature to achieve your requirement. Please download the guide and template file in the link below:

http://download.support.yealink.com/down...V81_20.pdf

http://download.support.yealink.com/down...V81_20.zip

Best Regards,
Lucia

Thank you for the response, but NO i cannot use this, as I had mentioned in another post.

There is no means to push a message to a phone without the IP address (They are on different WANs), and no means to get the phone to grab any possible new messages from except via the provisioning method.


I will look at the information you have included, and let you know.

Thank you!

EDIT: Nothing there for doing what I need. Anything else on the provision to send a message to the phone?