T19 & T2x second dial tone

[ac617]

Hi All,

1) does T19 or T2x support second dial tone with the dial plan? e.g. (9,x.)
2) also, does them provide individual time out setting? e.g. ([1-3]xx), when the dial fit to this pattern will dial immediately without to wait till time out

Thanks
Alan

[Yealink Support]

Hi Alan,

About the dial plan, please refer to below user guide from page 32.
http://www.yealink.com/Upload/T2X/201410..._V72_1.pdf

[ac617]

Thanks for your reply, i do read the menu, but i cant find any about the second dial tone.
Our users get used to hear a dial tone after they had pressed 9 before key in any digits else.
Is it possible to provide a second dial tone with the T19P or T20P?

Thanks
Alan

[CWR]

what if you hit 9 then send.
then you get a dial tone.
then dial your end number.

[ac617]

Hi Craigreilly,

Thanks for your reply.
sure that is one of the solutions.
Our case is we are planning to replace the aged pabx which used for >20yrs. I am thinking about how to let our users kept their behavior. Dial without press the "send" or "#" key etc.

[bascheew]

This can be done by setting the parameter "features.redial_tone = X"

where X is the number they use to dial out (commonly 9).

In the GUI this is under Features -> Audio -> Redial Tone.