T19 & T2x second dial tone - Printable Version +- Yealink Forums (http://forum.yealink.com/forum) +-- Forum: IP Phone Series (/forumdisplay.php?fid=4) +--- Forum: General topics (/forumdisplay.php?fid=15) +--- Thread: T19 & T2x second dial tone (/showthread.php?tid=1209) |
T19 & T2x second dial tone - ac617 - 01-23-2014 09:12 AM Hi All, 1) does T19 or T2x support second dial tone with the dial plan? e.g. (9,x.) 2) also, does them provide individual time out setting? e.g. ([1-3]xx), when the dial fit to this pattern will dial immediately without to wait till time out Thanks Alan RE: T19 & T2x second dial tone - Yealink Support - 01-23-2014 08:17 PM Hi Alan, About the dial plan, please refer to below user guide from page 32. http://www.yealink.com/Upload/T2X/2014102/Yealink_SIP-T2xP_and_SIP-T19P_IP_Phone_Family_Administrator_Guide_V72_1.pdf RE: T19 & T2x second dial tone - ac617 - 01-23-2014 11:10 PM Thanks for your reply, i do read the menu, but i cant find any about the second dial tone. Our users get used to hear a dial tone after they had pressed 9 before key in any digits else. Is it possible to provide a second dial tone with the T19P or T20P? Thanks Alan RE: T19 & T2x second dial tone - CWR - 01-24-2014 04:32 AM what if you hit 9 then send. then you get a dial tone. then dial your end number. RE: T19 & T2x second dial tone - ac617 - 01-24-2014 09:53 AM Hi Craigreilly, Thanks for your reply. sure that is one of the solutions. Our case is we are planning to replace the aged pabx which used for >20yrs. I am thinking about how to let our users kept their behavior. Dial without press the "send" or "#" key etc. RE: T19 & T2x second dial tone - bascheew - 03-03-2015 05:08 AM This can be done by setting the parameter "features.redial_tone = X" where X is the number they use to dial out (commonly 9). In the GUI this is under Features -> Audio -> Redial Tone. |