BLF on line keys

[jdackert]

T-28 is putting the BLF lines from the Broadworks BLF list on the open Line keys rather than the desired DSS keys.
I have one Line Account so with 6 lines in the BLF list, the 5 remaining line keys get a BLF line and the remaining BLF is on a DSS key.
The BLF lines don't show on the phone GUI Account x screens.
When I manually set each Phone>DSS Key>Memory Key with type "BLF List" and Line "Line1" and press Confirm, the screen reverts to only showing DSS Key 1 configure and there is no change on the phone.

Also, the Phone>DSS Key>Line Keys defaults to "BLF List" and "Line 1" and changes revert after Confirm.

I'd prefer a config file solution.


Thanks,
Jed

[Yealink Support]

Hi Jed,
You can disable this feature via auto provision parameter:
--------------------------------------------------
#Enables or disables the phone to automatically configure the BLF list keys.
#0-Disabled 1-Enabled The default value is 1.

phone_setting.auto_blf_list_enable = 0
--------------------------------------------------
Thanks.

[jdackert]

I set phone_setting.auto_blf_list_enable = 0 but it doesn't make any difference. When I add BLF in Broadworks the phone still puts them on the Line keys. I'm on v. 2.70.0.140 if that make any difference.

[jdackert]

I upgraded to 2.71.0.140 which stopped the Line key provisioning, but didn't provision the DSS keys.

phone_setting.auto_blf_list_enable = 1
phone_setting.blf_list_sequence_type = 1
features.pickup.blf_visual_enable = 1
features.pickup.blf_audio_enable = 0
account.1.blf.blf_list_uri = Yea-BLF

[Yealink Support]

Hi Jdackert,
Please try below parameter and check again:
---------------------------------------------
bw.directory_enable = 1
phone_setting.auto_blf_list_enable = 1
phone_setting.blf_list_sequence_type = 1
features.pickup.blf_visual_enable = 1
features.pickup.blf_audio_enable = 0
account.1.blf.blf_list_uri = Yea-BLF
---------------------------------------------
In V71 firmware, you should enable broadsoft featues first(bw.directory_enable = 1).
Any test result please let us know, thanks.

[jdackert]

bw.directory_enable was it Thank you!