Enhanced Remote Control

[raphael]

It would be very nice to have more remote control over the phone, for example to enable/disable call forwarding. For the T46 we use for that the Forwarding Button, but this is not possible for other models (T41 or other).

We created a workaround for that(http://forum.yealink.com/forum/showthread.php?tid=3361) but that is currently not working because of firmware changes.

thank you!

[James_Yealink]

Hi Raphael,

So you want to enable or disable call forward through a shortcut?
Maybe you can have a try of action URI. If you run in T41 V73 generic firmware please try this action URI command.

http://10.15.10.4/servlet?key=F4;DOWN;OK;OK;OK;RIGHT;OK

Replace the ip address with yours, this action URI command make phone to press button step by step bo enable/disable forwarding.

Regards,
James

[raphael]

Thank you very much James!

It's a very nice way to do that. I will try it.
Is that also working on V72?

[James_Yealink]

Yes, action URI also work in V72.
The action URI command may vary due to different menu.

[raphael]

Changing the forwarded number and to get the current forward status with action URI It's a bit complicated.

Any Chance that that http://$PHONEIP/servlet?forward=set&Forward_always_enable=1&Forward_always_target=$FORWARD_NUMBER
will be working also for the T2X and T41 in the future Firmware releases?
On the T46G that is working.

Thanks!

[timgrace]

same question.. solved