+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: Wishlist (/forumdisplay.php?fid=13)
+--- Thread: Enhanced Remote Control (/showthread.php?tid=3390)
Enhanced Remote Control - raphael - 03-05-2015 01:51 AM
It would be very nice to have more remote control over the phone, for example to enable/disable call forwarding. For the T46 we use for that the Forwarding Button, but this is not possible for other models (T41 or other).
We created a workaround for that(http://forum.yealink.com/forum/showthread.php?tid=3361) but that is currently not working because of firmware changes.
thank you!
RE: Enhanced Remote Control - James_Yealink - 03-05-2015 04:21 PM
Hi Raphael,
So you want to enable or disable call forward through a shortcut?
Maybe you can have a try of action URI. If you run in T41 V73 generic firmware please try this action URI command.
http://10.15.10.4/servlet?key=F4;DOWN;OK;OK;OK;RIGHT;OK
Replace the ip address with yours, this action URI command make phone to press button step by step bo enable/disable forwarding.
Regards,
James
RE: Enhanced Remote Control - raphael - 03-05-2015 04:44 PM
Thank you very much James!
It's a very nice way to do that. I will try it.
Is that also working on V72?
RE: Enhanced Remote Control - James_Yealink - 03-05-2015 10:17 PM
Yes, action URI also work in V72.
The action URI command may vary due to different menu.
RE: Enhanced Remote Control - raphael - 03-31-2015 04:53 PM
Changing the forwarded number and to get the current forward status with action URI It's a bit complicated.
Any Chance that that http://$PHONEIP/servlet?forward=set&Forward_always_enable=1&Forward_always_target=$FORWARD_NUMBER
will be working also for the T2X and T41 in the future Firmware releases?
On the T46G that is working.
Thanks!
RE: Enhanced Remote Control - timgrace - 04-24-2015 07:47 PM
same question.. solved