3cx autodiscover not working on Ubiquiti link - Printable Version +- Yealink Forums (http://forum.yealink.com/forum) +-- Forum: IP Phone Series (/forumdisplay.php?fid=4) +--- Forum: Auto Provisioning (/forumdisplay.php?fid=14) +--- Thread: 3cx autodiscover not working on Ubiquiti link (/showthread.php?tid=1681) |
3cx autodiscover not working on Ubiquiti link - engine411 - 05-01-2014 04:39 AM We use T46G's with 3CX, and normally when I bootup a new phone, it shows up easily in the 3CX Phones node. Today I did this via our wired LAN, and it worked just fine. Then I tried it at an outbuilding that's connected via Ubiquiti M5 point-to-point link, and there the autodiscover into the Phones node does not work. Has anyone experienced this with Ubiquiti radios? Our network is flat - no Vlan's, only one IP range. TIA. RE: 3cx autodiscover not working on Ubiquiti link - CWR - 05-01-2014 06:41 AM I think the ubiquity blocks multicast requests by default... I think that is where the requests come from for the server to "see" the phone. Have you done any wireshark traces? RE: 3cx autodiscover not working on Ubiquiti link - engine411 - 05-02-2014 08:15 PM Thanks for the reply! I turned Multicast on on the Ubiquiti radios, but that didn't make a difference. Then I just moved on... I only have a handful of phones using these PTP links, so I just provision them at my office and then deploy them. Thanks for the suggestions. |