Searching for Base

[Yealink Support]

Hi innovative_mike,

Yes, it may need to keep synchronization with the base when a new handset register to the base.
If your handset "searching for base" at intervals, please check below steps:

1. check whether your network is stable
2. disable LLDP to try again
3. in the idle interface of handset, press OK button->Settings->System Settings, make sure you don't enable ECO+ and ECO mode.

If you configure ECO mode, Eco mode greatly reduces the transmission power and signal output when the
phone is in the talk mode. The attenuation range is 20m. When the distance between the base station and the handset is over 20m, the eco mode is disabled automatically.

If you configure ECO+ mode, Eco mode+ turns off the transmission power and the radio waves emitted are virtually zero when the phone is in the standby mode. If the eco mode+ is enabled, and there is no signal interaction between the handset and the base
station, the color of the signal strength indicator on the idle screen displays in green. When a call comes in or a connection occurs, the phone exits the eco mode+ automatically, and the signal strength indicator on the idle screen changes from green to white.

4. reset the base to factory and try again.