Configure Yealink Phones autoprov and Action URLS on demand

[bomberyealink]

(08-13-2021 09:41 PM)adeo Wrote:  <snip>

Remark:
i had found in the Adminguide this :

http://admin:admin@192.168.200.158/servlet?phonecfg=set[&account.1.enable=1][&features.dnd.enable=1]

With that, i tried to set the ActionURLs, but there is no change and i get a cfg with only the Firmware-Version as response.

Cheers
Andreas

Bump!

I have the same issue, I'm trying to update a few trivial settings with the 'phonecfg=set' Action URI, but no changes get applied. The phone's LED (it's a SIP-T31G - the red LED at the top) blinks when I POST the http request, so I know the phone is getting it.

However, this problem does NOT happen when I use the 'phonecfg=get', this works fine and downloads the 'phonecfg.ini' file/data with no issue.

Any ideas?

Thanks, Peter