[YMCS/YDMP Free Trial Program]Yealink would like to offer Free Trial Program of Yealink device management service for our current eligible customers. You can see the details below.
https://www.yealink.com/ydmp-freetrial-2020


Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
CP900 is bricked after upgrading VC210 FW to 118.15.0.23
Author Message
sswinford Offline
Junior Member
**

Posts: 1
Joined: Feb 2019
Reputation: 0
Post: #6
RE: CP900 is bricked after upgrading VC210 FW to 118.15.0.23
I also encountered this problem after upgrading the firmware on our brand new VC210. Not a very good first impression with firmware bricking half of your setup...

When I was about to contact support, I did find this article on the CP900 Recovery Mode: http://support.yealink.com//faq/faqInfo?id=833

Basically, hold the power and volume down keys to power it off, then press them again to boot into recovery mode. You can then upload the latest firmware back onto it.

Plugging it back into the VC210 will cause it to go back to recovery mode

So for now I grabbed a spare USB power adapter that I had laying around and am using that to charge the CP900. It seems to be working fine over bluetooth audio.
Today 12:37 AM
Find all posts by this user    like0    dislike0 Quote this message in a reply
Post Reply 


Messages In This Thread
RE: CP900 is bricked after upgrading VC210 FW to 118.15.0.23 - sswinford - Today 12:37 AM

Possibly Related Threads...
Thread: Author Replies: Views: Last Post
  Upgrading the firmware is very complex nestman 4 4,566 03-02-2015 10:48 AM
Last Post: nestman
  Upgrading (T46G) won’t work ITSD 1 3,989 08-29-2014 02:44 PM
Last Post: Yealink Support

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us   Yealink   Return to Top   Return to Content   Lite (Archive) Mode   RSS Syndication