New Forum system requires email address which you used to apply for your account to replace your original username. Password stays the same.Please see this post for more details
http://forum.yealink.com/forum/showthread.php?tid=40344

Yealink Test Club has been officially launched. Please visit post below to get detail information. Come and join us!
http://forum.yealink.com/forum/announcements.php?aid=18

We just had the YMCS online and we are also working on the features plan on the future versions, in this regard we are need to hear your voice about the YMCS.
Please visit : http://forum.yealink.com/forum/showthread.php?tid=42322


Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cannot enter long distance code
Author Message
jolouis Offline
Moderator
*****

Posts: 307
Joined: Oct 2013
Reputation: 5
Post: #3
RE: Cannot enter long distance code
Are you connecting the CP960 directly to an analog line to do this, or is the dialtone prompt being generated by some kind of SIP PBX?

If its a PBX, that's a very strange behaviour because normally the call would be answered, the PBX would prompt you for the code, and then the system would dial out the call or tell you the code was invalid.

If it's an analogue line direct from a provider (or some kind of analog port on an old PBX) that makes more sense, but in those cases I'm pretty sure the answer is no, not possible, as the phone does not have a way of knowing when to present the dialpad and send digits. You might be able to convince Yealink to do a special version of a firmware build for you, but that seems like a lot of ask for one very unusual setup...
07-10-2019 08:21 PM
Find all posts by this user    like0    dislike0 Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Cannot enter long distance code - jolouis - 07-10-2019 08:21 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us   Yealink   Return to Top   Return to Content   Lite (Archive) Mode   RSS Syndication