Some XML help required

[jolouis]

(10-03-2018 10:59 AM)Eric.GoodAdvice Wrote:  The PBX does not support provisioning or the forward status by the phone, so i've been setting up XML to dial DTMF to set a static forward...

Not related to your XML specifically, but what exactly are you trying to achieve that the normal Call Forward feature of the phone itself would not do?

Yealink phones don't necessarily need any kind of hint or support on the PBX side to show the forward status, all you need is the pBX to support a forwarding DTMF code. If you configure this, when the user turns on call forward through the built in features menu/button, the phone will automatically transmit the DTMF code along with the phone number to the PBX as if the user had dialed it.

Similiarly, you can configure a DTMF code to be sent when call forward is turned off on the phone. Ideally those are two discreet codes to avoid confusion, but worst case you could use the same code and assume a toggle between the two states.

Take a look at the Features -> Forward & DND -> OnCode Off code options.