[YMCS/YDMP Free Trial Program]Yealink would like to offer Free Trial Program of Yealink device management service for our current eligible customers. You can see the details below.

Post Reply 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Configuration Yealink W52P for a GSM Gateway.
Author Message
Yea Offline
Junior Member

Posts: 2
Joined: May 2018
Reputation: 0
Post: #1
Configuration Yealink W52P for a GSM Gateway.
I am unable to establish a working line between the W52P and the Gateway.(This phone in its present state has a second line configured for an external VOIP service that is working fine.)
Incoming phonecalls work, outgoing phonecalls do not.
I am not using Asterisk or anything else then this gateway and the W52P and once they are configured I will disconnect WAN completely.
I want the W52P to use a mobile SIM and nothing else.
I really hope someone can help me out, because at this point I think I might have attempted all combinations brute force and I simply don't know where to go from here.

(hopefully) All relevant settings:

Firmware version:
Handset version:
Network Settings:
IP Address:
Primary DNS:
Subnet Mask:
Register Status Register Fail
Line active = Enabled
Label, Display Name, Register Name, User Name, Password = test
Enable outbound Proxy server, NAT Traversal = Disabled
SIP Server 1:
SIP Host =

Number assignement:
Headset1 is assigned for line 'test' for incoming as well as outgoing lines

SETTINGS Local Network
Router IP / internal network : / 192.168.0.x

SETTINGS GSM Gateway: Portech MV-372
Firmware: Ver = v10.115
Network mode: Bridged
WAN Settings:
Master IP:

Mobile to LAN Settings:
Item 0 | CID * | URL ;Accept all numbers and transfer to
LAN to Mobile Settings:
Item 0 | URL * | Call Num # ;No restrictions for the incoming IP address, one stage dialing.
SIP Settings
Mobile 1, Realm 1:
Display Name, User Name, Register Name, Register Password = test
Domain Server =
Proxy Server = -
Outbound proxy = -
Ports Setting
Port of Mobile 1:
SIP Port: 5060
RTP Port 20000
(This post was last modified: 05-31-2018 11:32 AM by Yea.)
05-31-2018 11:04 AM
Find all posts by this user    like0    dislike0 Quote this message in a reply
Post Reply 

Messages In This Thread
Configuration Yealink W52P for a GSM Gateway. - Yea - 05-31-2018 11:04 AM

Possibly Related Threads...
Thread: Author Replies: Views: Last Post
  W52P factory reset without password ralph 1 529 04-02-2020 03:05 AM
Last Post: Yisroel_MongoTEL
  W52p Repair Aliaksandr 10 2,281 02-10-2020 10:30 PM
Last Post: RobertoDSM
  Action URI in W52P RRC_Support 1 690 10-22-2019 01:27 PM
Last Post: Garry_Yealink
  W52P Sporadic behavior with auto answer csmith@ccexpert.net 2 4,277 09-27-2019 08:38 PM
Last Post: justingoldberg
  W52P Dect Interface "Settings" is missing ? CHRIYEA 1 1,111 06-06-2019 08:58 AM
Last Post: complex1
  W52P - Detected as Router and Telephone SG300 LLDP jmtread 1 2,639 12-21-2018 12:27 AM
Last Post: jmtread
  W52P admin pass after recovery crodaxy 1 2,014 12-04-2018 10:16 AM
Last Post: complex1
  W52P Handset Registration Fail CSPL 2 2,673 11-28-2018 06:00 AM
Last Post: CSPL
  W52P SfB Fred_ofi 0 1,247 10-18-2018 02:07 PM
Last Post: Fred_ofi
  W52P Issue with LLDP and VLAN ID derekb 2 3,919 07-22-2018 10:00 PM
Last Post: darwin.cabiluna

Forum Jump:

User(s) browsing this thread: 1 Guest(s)

Contact Us   Yealink   Return to Top   Return to Content   Lite (Archive) Mode   RSS Syndication