Paging Volume

[MattL]

I know this thread is old but it's still the first result on Google when searching for adjusting the paging volume.

SOLUTION:
Tested with firmware versions 66.81.0.110 and 66.86.0.15

Code:

multicast.listen_address.X.volume = 15

This parameter will adjust the listening volume for a specific multicast listening address. Replace the X with your multicast address number, e.g. multicast.listen_address.2.volume = 15. The volume range is anywhere from 1-15.

Code:

multicast.receive.enhance_volume = 1

This parameter will enhance the volume of the previously defined parameter above, increasing the volume range to 16-30. Setting the value to 0 disables this feature, setting the value to 1 enables. This only works if the multicast.listen_address.x.volume value is set to a number other than 0 (default).