Yealink 28.82.0.20

[complex1]

(11-27-2017 03:33 PM)Jarad Wrote:  I'm using Yealink T46G phones on a 3CX server and I am testing the new firmware before I push out the upgrade.

I have put this new firmware out on a few test phones and it's causing issues with placing and picking up shared parking slots. I've been testing to see if I can find a resolution, but so far nothing.

I do notice though in the web console of the desk phone 'Features > Pickup & Park > Call Park', that the 'Call Park Mode' setting has changed. In the newer firmware, only 'FAC' is available to use. In the older firmware that still works, located in 'Features > Call Pickup > Call Park' that the 'Call Park Mode' is set by default to 'XSI'.

The phone I'm currently testing on is a T46G with a hardware version of 28.2.0.128.0.0.0 and running firmware 28.82.0.20.

After several factory resets and firmware reinstallation, the problem persists. I was referred to this forum from the 3CX support forum. Staff of that forum informed me they were in contact with Yealink who recommended it.

---

I also have the configuration files available to send for more information if needed.

Hi,

Please enable the BroadSoft feature and try again.
It can be enabled by follow auto provision parameter:

bw.enable = 1

Hope this will help.