T46G how to disable the screensaver ?

[Lucia_Yealink]

Hi Sir,

Please see the detail below:

In V81, Yealink phone add two new features: Power Saving and Screen Saver.
Power Saving feature:
Simply speaking, you can configure your office hours. During the working hour, phone will not enter power saving mode and turn off the backlight. On off-work hours, phone will enter power saving mode after it has been idle for a certain period of time. All these durations can be configured through web interface and auto provision.
Screen Saver:
This feature configures the phone to initiate screen saver when it is on idle for a certain period of time. Replacing screen with moving pictures or a blank screen. It can be configured through user interface, web interface and auto provision. The feature is in order to avoid the afterimage on the color Screen when the phone is without any operation for a few days.

For more information, you can refer to the release note and the guide below:
http://download.support.yealink.com/down...on_V81.pdf
http://Yealink_SIP-T2_Series_T19(P) E2_T...V81_15.pdf

1. Can you check for me if the issue happened in the working hour or in the off office time(evenings and weekends)?
If the issue is happen in the working hour, please kindly provide the level 6 syslog, config.bin and pace trace when reproduce the issue to do more trouble shooting. For more information about how to get the three files, please refer to the FAQ below:
http://support.yealink.com/faq/faqInfo?id=313
2. I am afraid I am not clear about the ” if I put it to 15sec then the LOW setting is like value 1 in backlight the older firmware the LOW setting was like value 5 backlight”, can you kindly tell me the detail scenario or the detail operation? Thank you.

Any question, please let me know.

Best Regards,
Lucia Lu