T19 POE stopped working

[YMCS/YDMP Free Trial Program]Yealink would like to offer Free Trial Program of Yealink device management service for our current eligible customers. You can see the details below.
https://www.yealink.com/ydmp-freetrial-2020

Thread Rating:

0 Votes - 0 Average
1
2
3
4
5

Threaded Mode \| Linear Mode T19 POE stopped working
Author	Message

CWR

Moderator

Posts: 717

Joined: May 2013

Reputation: 7

Post: #2

RE: T19 POE stopped working

I have to ask - just so I can ensure you have done it - are you plugged into the LAN port from the POE Switch? I think most phones will work if plugged in backwards, but will not receive power unless the correct Jack is connected to POE source.

Craig Reilly
MCSA, 3cx Advanced Certified
Scottsdale, AZ

01-10-2015 04:48 AM

« Next Oldest | Next Newest »

Messages In This Thread

T19 POE stopped working - moduleit - 08-26-2014, 04:35 PM

RE: T19 POE stopped working - CWR - 01-10-2015 04:48 AM

Possibly Related Threads...
Thread:		Author	Replies:	Views:	Last Post
	MP50 working in Citrix	chinacat	1	5,034	08-15-2023 03:13 AM Last Post: ameyer22
	T23G Gigabit dont working	hesilva	0	3,079	07-13-2021 07:23 AM Last Post: hesilva
	Caller-id after attended transfer not working properly on T19P/T41P	ddyx	5	14,708	02-06-2018 08:01 AM Last Post: Lucia_Yealink
	Recovery Mode for T41P not working	Tonyn	1	10,277	11-21-2016 07:13 AM Last Post: Yealink_Michael
	SIP-T19P E2 DTMF not working with g.729	seulater	1	7,294	09-29-2016 11:29 AM Last Post: Travis_Yealink
	DTMF Relapce Tran not working correctly	1stvan	2	12,532	06-02-2016 02:07 PM Last Post: Robort2
	T19P E2 always forward not working	Lex	1	6,821	05-18-2016 07:15 PM Last Post: Lex
	Template update not working on T48G Expansion module	tas7330	2	10,019	04-28-2016 02:44 PM Last Post: Horence
	T28 BLF park not working correctly	ziggy5376	3	11,585	02-02-2016 10:13 PM Last Post: Karl_Yealink
	T26P/T28p BLF light not working after firmware upgrade	futures	2	14,804	01-27-2016 11:29 PM Last Post: janduy.manzanos@gmail.com

Forum Jump:

User(s) browsing this thread: 1 Guest(s)

Log in