Cant get the handset to Register

[Wilson_Yealink]

Hi MikeHughes@kube,

1.If the distance is too far or there are many block between the handset and base can cause the single attenuation. Then it will register fails.
Please close the base and then register again.
2.And another probaly reason is the base up to 5 handsets, please check whether you had registered 5 handsets to this base.

If it still can't work and you didn't register 5 handsets to this base , please try base hard reset and try register again. Generally, it will be ok. Please refer to a short video, you can get it from below link:
DECT_RESET