auto config

[Yealink Support]

Hi Paulhuynh,

The issue you mentioned is that:You wanted to remove the config on key 3 and move it to key 4 via Auto Provisioning ,right?
I don’t know which phone you used ,so I tested T42G in my side.
Let me show you the syntaxes in AutoP file below:
(for example,I remove the config on key 3 ,then set the type of key 4 to Speed Dial and its value=d)

##########################################
## Line Key ##
##########################################


###linekey.X.line =
###linekey.X.value =
###linekey.X.pickup_value =
###linekey.X.type =
###linekey.X.xml_phonebook =
###linekey.X.label =

1.If you want to remove both type and value of key3.
linekey.3.type = 0 (0=N/A)
linekey.4.value = d
linekey.4.type = 13 (13=Speed Dial)
After the auto provisioning process is completed, the key 3 is blank and the key 4 is setted to Speed Dial and the value is “d”.

2.If you want to remove the value of key 3 only.
linekey.3.type =13(13=Speed Dial)
linekey.3.value = %NULL%.
linekey.4.value = d
linekey.4.type = 13 (13=Speed Dial)
After the auto provisioning process is completed, the type of DSS key 3 will be Speed Dial ,and its value is empty. The key 4 is setted to Speed Dial and the value is “d”.

Note: If you want to reset the configuration of a parameter, set the value of the parameter to %NULL%.

And you can refer to AutoP guide for detail.

Thanks