How to get Auto Redial to work on T48G

[Frank Drews]

Hi Andreas,

call Completion is for internal calls only. What behaviour do you exprience in internal calls?
You need some status info, too, to make it work. E.g. if a BLF key for the extension shows the correct status, auto redial should work, too.

Best regards Frank

(05-23-2016 04:02 PM)Andreas Irmer Wrote:  I am using a T48G in my office and I am struggling with the auto redial function. It is activeated in the settings but when I dial an number and the other end is busy it always stays on the busy tone but does not redial the number after some seconds.

What is my erroro here?

I am using the phone with only one account on a fritzbox 7490

Firmware is on the actual version 95.

Thanks a lot in advance for your comments.