T41P Custom logo file TFTP only?

[JamesK]

(11-26-2013 10:25 AM)Yealink Support Wrote:  Hi JamesK,

Yes. You can use other server like ftp or http/https.
About your issue , make sure the resolution of the SIP-T42G/T41P IP phones is 192*64 graphic and your dob file should be limit to it.

ok that is good to know. I have been working on this on and off yesterday with no luck. I kept trying http but could not get anywhere. So I decided to give up and go to tftp to see if I can make it work. No luck really there either.

Here is what I did.

1. Put the 192x64 dob file in my 3CDaemon TFTP folder. Only file in there.
2. Turned it on. Took ip address from it put it the field as follows:
lcd_logo.url = tftp://192.168.2.11/image.dob
3. Saved it.
4. Let the phone autoprovision and pull configuration file down.
5. Verified that Custom Image is on but no image downloaded
6. Checked 3CDaemon, the phone failed to reach out and hit tftp.

This is where the problem is. The phone is not reaching out and trying to pull down the file. Not sure where the disconnect is. I am running firmware 36.71.0.60 on the T41P phone.

Question is why is the phone not reaching out? is it possible the lcd_logo.url = is wrong? I have seen that before on this same phone when it came to the linekey.2.extension = which is the correct one. There was a post about it somewhere on here and it was to be corrected on the pull down files but, it has not been and is not going to be until after dec or jan i forget.