W52p Repair

[RobertoDSM]

(02-05-2020 04:08 PM)complex1 Wrote:  

(02-05-2020 03:46 PM)RobertoDSM Wrote:  

(02-03-2020 07:43 PM)complex1 Wrote:  Hi,

If the handset is still connected to the base station, you can use it to find out the IP address.

Also do not use PoE, use external power supply instead.

Hope this will help.

Hi,

That's the problem, the base doesn't even connect to the network and therefore it doesn't have an IP address.
And i don't use PoE.

Thank you.

Hi,

Assuming the handset is still registered to the Base then press OK button and select “Status” - “Base”.
Now you can read the IP-address (Base Firmware, MAC, Certificate, etc.) of the Base.
Use a PC, set his IP in the same range as the Base is and try to log into the Base.

BTW: What IP-address and firmware version do you read?

Hi,

The handset is always searching for base, and when I press OK button and select Status > Base, it shows zeros for everything.

Thank you.