T28P & T38G: Speed Dial delay or pause between DTMF

[tim942]

(01-24-2017 02:49 PM)Rogier Wrote:  * Go to DSS keys
* Create new speeddial entry
* Everything that is not the primary phone number needs to be put in the extension Field (so not in the Value field).
* Use <#> as the pause sign, where # needs to be replaced by the number of seconds you would like to wait. So you would use "<5>" for 5 seconds...

I couldn't get this working in v80, but I got it working in v81:

1. Enable EDK in config file (no UI enable at this time)
2. select the DSS key type "Custom Key"
3. Enter the macros with the numbers in the values. Example: 1231231234$Cwc$$Cp3$123$Tdtmf$

$Cwc$ - Macro to wait until call is connected before continuing
$Cp#$ - Macro to wait for # seconds
$Tdtmf$ - Macro to submit the preceding numbers in dtmf (123 in this case)

Right now, this only works as the Custom Key in DSS. If we can get this setup in the Address Book, I can get my users out of my hair over this.