I chose to export All-Settings-CFG on my T46G and was able to add the line from Lucias config file (thank you!). But this will only disable the wake up of the display when there is a call on another phone that is registered to my BLF function.
The main problem - all LEDs are flashing red if one of the configured phones receives a call - is still there. It wasn't there, however, on earlier firmware versions.
For example - if I flash version T27-45.80.0.95 on my T27p then the proper BLF is flashing when the other phone receives an incoming call. Going back to the latest firmware shows the explained problem, that all BLF LEDs are flashing if ONE configured phone receives a call.
(12-05-2016 12:32 PM)Lucia Wrote: Hi Sir,
About your problem, please use the parameter below to do auto provision:
features.blf_active_backlight.enable=0
##It enables or disables the IP phone to turn on the backlight or stop the screen saver when the BLF/BLF list status changes.
#0-Disabled
#1-Enabled
If the problem still exist, then please provide the level 6 syslog, config.bin and pace trace when reproduce the issue to analyze.
About how to get the three files, please refer to the FAQ below:
http://support.yealink.com/faq/faqInfo?id=313
Also, how many phones you have in total?
Best Regards,
Lucia
I just traced it and attached is the log file from my T46G, currently running 28.81.0.20.
I have 1 x T46G and around 10-15 x T27P in our office.
I have 7 BLFs configured, all of them use the phone T27P. I am the only one with a T46G. Only phones with the recent firmware have the problem.
