phone stating in LLDP that it is half duplex

[mikes]

(05-06-2015 12:18 PM)mikes Wrote:  

(04-24-2015 11:41 PM)Yealink_James Wrote:  Hi Mike,

Very sorry. They are leaving for anual trip these days and will back on next Monday.
I just check in a T41 with V73 firmware. It seems that phone send a correct capability. Not quite sure whether it's an issue in firmware 36.71.19.6.

.... .1.. .... .... = 100BASE-TX (full duplex mode): Capable
.... 1... .... .... = 100BASE-TX (half duplex mode): Capable
...0 .... .... .... = 100BASE-T4: Not capable
..1. .... .... .... = 10BASE-T (full duplex mode): Capable
.1.. .... .... .... = 10BASE-T (half duplex mode): Capable
0... .... .... .... = Other or unknown: Not capable

May I know who direclty sell phone to you? Maybe you can also contact them for an instant support. Our guys will check the issue in Monday.

Regards,
James

---

Tadiran Telecom sells to us directly.

Here is the output of the switch "sh lldp neighbors detail" It shows the phone Speed/duplex: 100baseTXHD. I have contacted Tadiran and they say it is a Yealink issue. Yealink generates the software for them. How is the phone performance being impacted by operating at half duplex?

Chassis ID: 192.168.21.121 (Network Address)
System Name: T4X_SPI
Device Port: 00:0A:6B:03:B3:E3 (MAC Address)
TTL: 166
Capabilities: Bridge, Router, Telephone
Enabled Capabilities: Bridge, Telephone
Local Port: giga-swx 0/7
Management Addresses:
Auto-negotiation: enabled
Speed/duplex: 100baseTXHD
LLDP-MED Enabled Capabilities:
Capabilities, Network Policy, ExtendedPD, Inventory
LLDP-MED Network Policy:
Application - Voice
Cos/DSCP - 6/46
VLAN ID - 4 (tagged)

Please have someone test the version I am using. 5/5/15

Thank you Mike

---

So is this a firmware issue? If it is, can Yealink please inform Tadiran Telecom of it so they can get updated firmware? I still have no resolution to the my issue. Mike Schrader 5/17/2015 7:06 pm PST