W52p

[Yealink_Peter]

(12-19-2014 02:16 AM)jeffi Wrote:  I can't get my W52p to obtain an IP address in DHCP.
Nor can I get it to work in Static mode. Any suggestions.

Hello Jeffi,

Please make sure your using network cable can work well by other phone or PC, and connect to another switch port test.
If the network indicator from the base still die out or flashing, please try a hard reset.
-> How to reset the system PIN?
1. Disconnect the power adapter.
2. Long press the paging key and reconnect the power adapter.
When base station finishes reset, the power indicator LED, network status LED and registration LED illuminate in sequence. System PIN and all individual settings are reset to factory defaults. Handset registrations will also be cleared after base station reset.

Best Regards,
Peter