ACTION URI error

[mleiphamellis]

Hello, just commenting to say I am running into the same trouble with the T54W and determined to figure it out! I also have "Action URI Allow IP List" set to "any" and can typically run it a couple times before getting the error.

Firmware Version: 96.85.107.5
Hardware Version: 96.1.2.0.2.1.2

I've reproduced this behavior on two phones on two different LANs, both provisioned with config files from the same provider. Next step is to turn up the logging level as described in the Yealink article "How to Get Correct Diagnostic Files from Yealink Phones", reproduce the problem, and look for clues in the logs.

I'm also on a Mac and want to get a handle on this behavior before integrating dialing capabilities into an Alfred workflow. I'm curious to find out if our systems have some application in common that's doing some pre-fetching with a URL on the clipboard or something.

I'll follow up in the next few days with any clues or breakthroughs.