(05-20-2022 04:01 PM)markvdheijden Wrote: (05-20-2022 01:08 AM)Chris708 Wrote: I have 3 Yealink T54W's, firmware 96.86.0.45. Each of these has a DD10K plugged in and each is registered to a single/separate W56H handset.
Handset firmware is 61.83.0.90.
I am now trying to register an RT30 to the T54W with the DD10K and neither can see each other.
Powering on the RT30 shows a Green Power light and Orange-flashing DECT light.
*Manual says this is Registering to a Base station
*Manual also says that powering on the RT30 should show a Green Power light with a Red-Flashing DECT light.
The T54W is set to Repeater Mode RT30.
When I Start Reg on the T54W, it just shows Repeater at the top of the screen with a spinning/search circle.
When I quick press the Program key on the RT30, the DECT light goes from flashing-Orange to solid-Red.
Basically, I don't believe I am able to register the RT30 to any of the Yealink T54W's with DD10k.
Looking for your assistance on getting these to register.
As stated in the datasheet the RT30 is compatible with Yealink W60B/W70B/W52 DECT IP Base stations. So I do not think you can register it to a DD10.
I have found the datasheets do not always have up to date information.
Also, from my testing, the DD10K, when installed in the phone, shows support for the RT10/20 AND the RT30.
Also, though the Yealink DD10K datasheet doesn't say it supports the Yealink T54W, the T54W datasheet says it supports the DD10K.
Also, the DD10K FAQ says it is supported by the RT30.
https://support.yealink.com/en/portal/do...a65efac159
"Does DD phone support Yealink DECT repeater RT30? Yes"
So, although the RT30 Datasheet doesn't say it supports the DD10K, most information points to some type of interaction between the T54W using the DD10K and the DD10K interacting with the RT30.
Perhaps there is a way to get these to work given the above information --- even if it requires some other piece of equipment?
Do you have any suggestions?
Right now, I am continuing to do my own research.
