[YMCS/YDMP Free Trial Program]Yealink would like to offer Free Trial Program of Yealink device management service for our current eligible customers. You can see the details below.
https://www.yealink.com/ydmp-freetrial-2020


Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Audio problems on phones (t23g i t42s)
Author Message
complex1 Offline
3CX Adv. Cert. Engineer
*****

Posts: 1,509
Joined: Jan 2014
Reputation: 43
Post: #2
RE: Audio problems on phones (t23g i t42s)
(12-01-2020 12:10 AM)bob_1921 Wrote:  Hi,
I have one interesting situation with a series of t23s and t42s phones. Before I describe the problem brief introduction: I have installed over a hundred phone combination t23g i t42s series, on some maybe ten cases the phones are behaving strangely. During the day on some maybe ten phones, happen that three or four calls have difficulties, the audio does not reach the phone. (pbx configuration is ok, also network configuration is ok), when I go to the location where the phone is and I test everything is fine.

The hardware part of the phone is fine, as well as the configuration of the pbx and voip network, it is interesting that when I replace the phone with a new one, the problem disappears and I put the phone that caused the problem in another location and there is no problems, phone work fine ...
I've researched a bit and seen I don't know if I'm right that yealnik requires that RTP ports be set in the range of 11780 to 11800, and that's the configuration on all phones i have instaled.

What do you think, Is this the reason for the difficulty white audio on some phone, because I put this range of RTP port, same on all phones. Do I need to expand the range of RTP ports on the phone and after how many configured phones should it do (Now the range of RTP ports is set to 11780 11800).
Thanks!

Hi,

A possible SIP ALG setting in the router can cause the issue, please disable it.
If you use more than one device in the office and the PBX is in the cloud, possible you need to setup each device its own local SIP port and RTP port range.
e.g.
Phone 1, local SIP port: 5062, local RTP port 14000-14019
Phone 2, local SIP port: 5064, local RTP port 14020-14039
Phone 3, local SIP port: 5066, local RTP port 14040-14059
and so one...
Also each device need to have it own fixed LAN IP address so the PBX can "find" the phone.

Hope this will help.

Kind regards,
Frank.

I am not an employee of Yealink.
Dutch is my native language, not English. Apologies for my imperfect grammar.
Please do not send unsolicited PM messages. I will not answer them.
12-02-2020 12:43 AM
Find all posts by this user    like0    dislike0 Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Audio problems on phones (t23g i t42s) - complex1 - 12-02-2020 12:43 AM

Possibly Related Threads...
Thread: Author Replies: Views: Last Post
  T23g TFTP ahidalgo 7 19,558 01-22-2024 07:25 PM
Last Post: complex1
  Phones no longer support Let Encrypt johnbeaumont 20 31,335 01-19-2024 08:09 AM
Last Post: tom-nbb
  Yealink T58W and Grandstream UCM6308 delayed audio on outgoing calls waltersjo 2 1,689 12-19-2023 11:10 PM
Last Post: waltersjo
  Firmware phones T33G esoriano 1 884 12-13-2023 02:50 AM
Last Post: complex1
  MP54 Teams phones sometimes fail to log in jzcase 0 670 11-21-2023 12:26 AM
Last Post: jzcase
  Phones without a "server/PBX" kermitxyz 0 653 11-13-2023 02:26 AM
Last Post: kermitxyz
  MP56 with EXP50 Side Car Problems rockey@autechllc.com 1 2,447 08-09-2023 02:53 PM
Last Post: lomotex
  Audio Delay - Disable Jitter Buffer? joni1802 4 2,445 07-17-2023 10:20 PM
Last Post: complex1
  WH67 softphone problems whatunga 1 2,067 04-13-2023 02:12 PM
Last Post: whatunga
Question T23G Recovery Mode Upload Fail stan0ne 7 19,903 03-27-2023 10:21 PM
Last Post: nolto

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us   Yealink   Return to Top   Return to Content   Lite (Archive) Mode   RSS Syndication