(07-15-2015 01:13 PM)tatak Wrote: Hi all,
Ive been trying to configure a "click to call" feature so that website phone numbers are clickable and will dial out from the desk phone. T46 and T48 phones.
I have downloaded a firefox addon called Telify which is supposed to do the job using an action URI.
According to the yealink admin guide I can use the following uri to get the phone to dial out:
http://user:pass@%phoneip%/servlet?number=%number%&outgoing_uri=%account%
Ive edited the url with my credentials and numbers etc. and tried this from the web browser but all I get is a big fat nothing, blank page.
I have enabled "any" under features>remote control and even tried it just with my pc IP but still nothing.
Also to add to this ive gone into directory>phone call info and tried to dial from there, it says Success but nothing happens!
any ideas of what I can try? grasping at straws now.
Thanks
hi
thanks for your information
1. please make sure your phone firmware is greater than x.72.x.x , if not , please upgrade the firmware first , firmware download link :
http://support.yealink.com/documentFront...isplayPage
2. please focus on the LCD of the phone , the first you use the URI , then the LCD will show :Warning : Allow Remote Control ?: if you see this , please press OK , and then you can use the URI successfully
3. try again to make the URI format is correct, it should be like below :
http://admin:admin@10.17.3.37/servlet?nu...g_uri=8527