(07-03-2019 03:13 PM)Chris708 Wrote: Export your .cfg file for both phones and make sure the multicast addresses match.
Also, newer Yealink firmware has a Channel setting int he Multicast paging. I have not tested that so I left it out and it still works. It may default the channel to 0 when not specifically set via cfg file.
This is the Page All for one of our clients
--------------------------
### Listen Address ###
multicast.listen_address.1.label = Page All
multicast.listen_address.1.ip_address = 224.0.0.1:10001
multicast.listen_address.1.channel =
### Paging Address ###
multicast.paging_address.1.label = Page All
multicast.paging_address.1.ip_address = 224.0.0.1:10001
multicast.paging_address.1.channel =
-------------------------
I haven't worked with a Video phone so not sure if there is something different there but I reviewed the 58V and it seems no different than other Yealink Phones.
-------------------------
There is also a setting I found that will disable multicast paging. You can check that setting.
---
Paging Priority Active
Paging Priority Active feature decides how the phone handles incoming multicast paging calls
when there is already a multicast paging call on the phone. If enabled, the phone will ignore
incoming multicast paging calls with lower priorities, otherwise, the phone will answer incoming
multicast paging calls automatically and place the previous multicast paging call on hold. *** If
disabled, the phone will automatically ignore all incoming multicast paging calls.***
---
Thanks for the additional info.
Still no go.
I factory reset them, but still has issue receiving Multicast on the Yealink T58v.
I'll have to do more troubleshooting later.