Yealink T28 - NO SPACE LEFT - When uploading custom ringtone - No Online Fixes ???

[Tony23232]

Dear all,

Recently went on my Yealink T28 phone which has been updated with the latest firmware.

Under 'settings' > 'preference' > 'upload ringtone' I proceed to upload a custom ringtone which was in a .wav format.


It uploaded about 20% of the file then the webinterface crashed and the phone restarted.

I checked the phone after it rebooted up and the uploaded ringtone WASNT there.

I then read a guide on the internet saying that the .wav file has to be 8000 / 16bit / mono and the file size shouldnt exceed 100/kbs.

I then edited the .wav file using 'cooleditpro' and made sure the file was of these specs.

I then logged back into the web interface and tried to upload. I now get the message "No Space Left"

Obviously a portion of the previous upload has made its way onto the phone and now the phone is full and I can't upload anything else.

Anyway that we can sort this out as there must be a way to TFTP to the phone all some software that can clear off the custom ringtone uploads.

Right now I cant upload anything else and there is no way to change anything???

I have searched google and seen some other similar forum posts on here, but there has been no answers.

Ideally I dont want to reset the phone or reflash the firmware because it is being using in a busy office and has alot of other config settings that I have setup etc and ideally I dont want to do any type of reset either.

Please help and advise as this is a very simple yet frustrating problem to have.

Regards, Tony