T27 V80 Firmware - BLFs Inoperable with Freeswitch

[Abe1048]

(06-04-2015 05:29 PM)Flora Wrote:  Hi Rob,
For the transfer issue, do you mean the scenario is like below,
T27 are in the call with another party B
T27 press transfer button, dial B's number and press OK button , when B answer the call , T27 press transfer button again ,right ?
in this case, T27 first should send Invite message to hold B and then send the Refer message and when inbound call, the phone send the invite message normally but the server response with 481 . is there any brand phone that can work well？

If yes, would you please share us the pcap trace for the working brand phone?
and also ,please provide us config.bin file , pcap trace and level 6 syslog for these two scenarios that we can ask the engineer to check .
You can refer to below link,
http://forum.yealink.com/forum/showthread.php?tid=1319
Best Regards!
Flora



BTW, normally one thread just for discussing the same topic , please open a new thread for a new topic.


Best Regards!
Flora

Good News Everyone!

We got an email from Yealink support with a new Firmware resolved the BLF issue.