Change vlan setting to more than one phone at once

[xrpapak]

(11-17-2014 02:27 PM)Yealink_Jim Wrote:  Hi,
I suggest that you can enable vlan for both PC and WAN ports via Auto Provisioning. Given below is the configuration parameters:

-------------------------------------------------------------------
#!version:1.0.0.1
#Enable or disable the VLAN of WAN prot; 0-Disabled (default), 1-Enabled;
#Require reboot;
network.vlan.internet_port_enable =

#Configure the VLAN ID, it ranges from 0 to 4094, the default value is 0.
#Require reboot;
network.vlan.internet_port_vid =

#Configure the VLAN priority, it ranges from 0 (default) to 7.
#Require reboot;
network.vlan.internet_port_priority =

#Enable or disable the VLAN of PC port; 0-Disabled (default), 1-Enabled;
#Require reboot;
network.vlan.pc_port_enable =

#Configure the VLAN ID, it ranges from 0 to 4094, the default value is 1.
#Require reboot;
network.vlan.pc_port_vid =

#Configure the VLAN priority, it ranges from 0 (default) to 7.
#Require reboot;
network.vlan.pc_port_priority =
-------------------------------------------------------------------------------------------

Yealink IP phones support FTP, TFTP, HTTP, and HTTPS protocols for auto
provisioning and are configured by default to use theTFTP protocol.
Briefly, the procedure is to prepare a TFTP server, put the configuration CFG file to the TFTP server, then enable the phone to update the firmware via the TFTP server.



You can refer to below Auto Provisioning guide for more information:

http://www.yealink.com/Upload/T2X/2014.3...V72_30.pdf

Hope this helps!

Hello Yealink_Jim,

Thanks for your answer,

I would like to avoid auto provisioning ip phones via tftp server. That's because this means I should configure each phone separately to know tftp server, then take each phone's MAC address and configure its MAC.cfg file, setup <y000000.cfg> file and reboot for all phones. As a result, doing the above process I realize infrastructure changes and I haven't planned the impact.

I imagine something like the following http://<phone_ip_address>/cgi-bin/ConfigManApp.com?key=Reboot which is used for rebooting a phone remotely. Something like that for exporting the configuration file, make the changes regarding vlan settings, importing again and rebooting the phones.

Is it possible something like this happens?