Disable switching between logo and information

[Sasheem]

Hello,

I am trying to configure a logo on a T26P. Working so far, logo is being displayed. Problem is that it keeps showing for a few seconds, then the screen shows the account details again, then the logo ... and so on.

Is there a possibility to set so the logo stays until you pick up or press a button or something ?

Thanks in advance,
Kai

[Yealink Support]

Hi Kai,
Sorry currently we can't support it(stay logo), because of the LCD, but our T28 can support it.
Thanks.

[Sasheem]

Hi,

Thank you for the reply. Ok, then I will leave it up to our users for now if they mind the blinking or not.

[jdackert]

Some of our customers complain about this, too. Any chance the switching could be disabled in a future .rom?

---

On the T20 GUI, you can blank out the Features>General Information>Text Logo field and set Use Logo to disabled. The phone display will stay at Line Label, as desired.
I can't figure out how to reproduce this with a config file. I can't set phone_setting.lcd_logo.text = to blank. I've tried quoting space with symbols ` `,' '," " but it displays the quote marks.

[Yealink Support]

Hi jdackert,

Please test below syntax.
---------------------------------------
#!version:1.0.0.1
#0-Disabled, 1-Enabled
phone_setting.lcd_logo.mode = 0
---------------------------------------