Trigger Call?

[dapster105]

Thank you - click to dial now works perfectly!

There is one small issue with this new firmware. Every few seconds the phone screen flashes up with a big Yealink logo which is quite distracting. Is that because this is a beta firmware or is there some new setting that I need to switch off?
I'm holding off rolling out this firmware because I know I'm going to get complaints about it from the users - it flashes up for about 2 seconds every 10 seconds which is quite irritating.

A second question is, where can these updated firmwares normally be found? I couldn't find this version on the Yealink site anywhere.

Thanks for your help with this!

---

(10-29-2013 05:11 PM)dapster105 Wrote:  There is one small issue with this new firmware. Every few seconds the phone screen flashes up with a big Yealink logo which is quite distracting. Is that because this is a beta firmware or is there some new setting that I need to switch off?

Ok - found it way down the bottom of the Features->General Information section. "Use logo" now Off.

[Yealink Support]

Hi dapster105，

1. You can turn off the logo in the webpage->Features->General Information->Use Logo, turn it off.(attachment)

2. You can find the latest version in the Support module of yealink site. I make a screenshot for all of you.

[luppas]

Hi Guys

Has the remote dialing command for the T48 changed form the T46? Is it still

http://username:password@IPADDRESS/servlet?number=PHONENUMBER&outgoing_uri=SIPUSER@SIPSERVER

Or does the T48 have a new command for remote dial?

Thanks

[Yealink Support]

Hi luppas,

Can you use the same command in T46G and work well?
I think the correct command should be:


http://username:password@IPADDRESS/servlet?key=number=PHONENUMBER&outgoing_uri=SIPUSER@SIPSERVER