Configure Yealink Phones autoprov and Action URLS on demand

[adeo]

Hi There,
i have programmed a software to use the action URLs.

The problem are the Client Desktops that usese DHCP (Laptops).
They changes often the IP-Adresses, so i have to change the IP-Adress in the actionurls to the Client.

My Question:
Is there a way to set the Action URLS from my Clientsoftware ?

the Provisioning of the Phones comes from the PBX, but the ActionURLS are set from me for every phone.

My software knows the IP-Adress of the Phone and the IP-Adress of the Client PC.
Now i will set the Actionurls on every start of the Program.

Any Ideas ?

Remark:
i had found in the Adminguide this :

http://admin:admin@192.168.200.158/servlet?phonecfg=set[&account.1.enable=1][&features.dnd.enable=1]

With that, i tried to set the ActionURLs, but there is no change and i get a cfg with only the Firmware-Version as response.



Cheers
Andreas

[bomberyealink]

(08-13-2021 09:41 PM)adeo Wrote:  <snip>

Remark:
i had found in the Adminguide this :

http://admin:admin@192.168.200.158/servlet?phonecfg=set[&account.1.enable=1][&features.dnd.enable=1]

With that, i tried to set the ActionURLs, but there is no change and i get a cfg with only the Firmware-Version as response.

Cheers
Andreas

Bump!

I have the same issue, I'm trying to update a few trivial settings with the 'phonecfg=set' Action URI, but no changes get applied. The phone's LED (it's a SIP-T31G - the red LED at the top) blinks when I POST the http request, so I know the phone is getting it.

However, this problem does NOT happen when I use the 'phonecfg=get', this works fine and downloads the 'phonecfg.ini' file/data with no issue.

Any ideas?

Thanks, Peter