Missing Display Info after upgrade to 28.80.0.70

[Ken Dever]

Before the upgrade when a call was parked it would display Park 1, Park 2 etc.

After the upgrade nothing displays.

Is this a PBX issue that they need to make a change or something else.

Programming is as follows:

Type = DTMF Value = *58 Label = Park In

[Yealink_Michael]

hi

do you mean that when using the old firmware and press the DSS Key which is set to park , then there is a display showed on the LCD like Park 1, Park 2 etc., but the .70 firmware will not?

if yes, please reset the phone to factory and test again .

if the issue still exist, please provide us the trace file for future analysis,trace file including pcap file, config bin and syslog file , and we need three of them provide at one time.

for how to get them , please refer to the FAQ below:
http://forum.yealink.com/forum/showthread.php?tid=1319

please provide the trace file in old firmware also for compare

please send to support@yealink.com