snusnu
Junior Member
Posts: 2
Joined: Sep 2018
|
T46S + EHS36 + Jabra 920 = Long delay
Hi folks,
we are using a combination of T46S, EHS36 and Jabra 920. Everything is working ok, but there is a long delay (3-5 seconds) to end a call by pressing the designated switch on the Jabra 920. We almost set the call control mode fix to DHSG but that didn't changed anything. With an old Alcatel telephone the same headset is running very well.
So do you have any ideas to get rid of this annoying delay?
T46S Firmware Version: 66.83.0.35
EHS36 Hardware Version: 48.16.0.0
EHS36 Firmware Version: 4.16.0.0
|
|
| 09-24-2018 12:33 PM |
|
complex1
3CX Adv. Cert. Engineer
Posts: 1,448
Joined: Jan 2014
|
RE: T46S + EHS36 + Jabra 920 = Long delay
(09-24-2018 12:33 PM)snusnu Wrote: Hi folks,
we are using a combination of T46S, EHS36 and Jabra 920. Everything is working ok, but there is a long delay (3-5 seconds) to end a call by pressing the designated switch on the Jabra 920. We almost set the call control mode fix to DHSG but that didn't changed anything. With an old Alcatel telephone the same headset is running very well.
So do you have any ideas to get rid of this annoying delay?
T46S Firmware Version: 66.83.0.35
EHS36 Hardware Version: 48.16.0.0
EHS36 Firmware Version: 4.16.0.0
Hi,
Please upgrade the T46S Firmware to v84 and try again.
http://support.yealink.com/documentFront...mentId=143
Hope this will help.
Kind regards,
Frank.
I am not an employee of Yealink.
Dutch is my native language, not English. Apologies for my imperfect grammar.
Please do not send unsolicited PM messages. I will not answer them.
|
|
| 09-25-2018 07:32 AM |
|
