How to unhold a specific call using Action URI

[nSolvePaul]

Via Action URI we can use the key=F_HOLD command to unhold a call, this works fine when there is only one call.

When there are two calls on hold how can I tell the phone via action URI to unhold the call I want to unhold?

---

And if there are 3 held calls the issue is even more complex. The action URL/URI system needs to support passing the CSTA_ID so exact call control is possible.

[Jensen_Yealink]

(08-01-2018 03:16 PM)nSolvePaul Wrote:  Via Action URI we can use the key=F_HOLD command to unhold a call, this works fine when there is only one call.

When there are two calls on hold how can I tell the phone via action URI to unhold the call I want to unhold?

And if there are 3 held calls the issue is even more complex. The action URL/URI system needs to support passing the CSTA_ID so exact call control is possible.

Hi nSolvePaul,

Please refer to below:
ASW/CANCEL/HOLD/UNHOLD:xxx
It means: Answer/end/hold/unhold a call (xxx refers to the call-id of the active call).
Example: http://10.10.20.10/servlet?key=ASW:33093.
More detail please refer to admin guide, page 644:
http://download.support.yealink.com/down...V82_22.pdf

BR
Jensen