T42G Programable Key as park call

[jasonblewis]

Hi,

Is there some way to program one of the horizontal programable keys on a T42G to park a call to extension 70?

I can configure a LineKey to do it very easily and it works well, but as far as I can tell there is no way to configure this to one of the programable soft keys.

any ideas?

tia

[Klaus_Yealink]

Hello,

Please try to configure the softkey layout, then test again.

Path: webUI>>settings>>softkey layout.

BR

klaus

[jasonblewis]

Hi Klaus,

There is no option there for park call. only the following:
Empty, Mute, Swap, New Call, Switch Account, Answer, Reject. and in the Selected Softkeys column: Transfer, Hold, Conference, Cancel.

Jason

(10-19-2017 10:14 AM)Klaus Wrote:  Hello,

Please try to configure the softkey layout, then test again.

Path: webUI>>settings>>softkey layout.

BR

klaus

---

Could it be achieved with macros somehow?

(10-19-2017 10:46 AM)jasonblewis Wrote:  Hi Klaus,

There is no option there for park call. only the following:
Empty, Mute, Swap, New Call, Switch Account, Answer, Reject. and in the Selected Softkeys column: Transfer, Hold, Conference, Cancel.

Jason

(10-19-2017 10:14 AM)Klaus Wrote:  Hello,

Please try to configure the softkey layout, then test again.

Path: webUI>>settings>>softkey layout.

BR

klaus

[Klaus_Yealink]

Please use auto p feature to configure below sentence :

bw.enable = 1
bw.xsi.enable = 1

then it will be ok.

BR

klaus

[jasonblewis]

Ah thanks. this is interesting. that worked I was able to added a park key. however it then asks you for the park extension. can i program the park extension too?

(10-24-2017 02:13 AM)Klaus Wrote:  Please use auto p feature to configure below sentence :

bw.enable = 1
bw.xsi.enable = 1

then it will be ok.

BR

klaus