Off-Hook Dialtone

[Dalton]

Hi There

I am looking to enable the dialtone that one hears when picking up the handset, but when a call is terminated. So when the call is terminated, the active line goes dead as well, so one does not hear the dialtone even when the handset is off the hook. One needs to visually monitor the display of the phone to determine if a call is no longer active.

I want to know if it's possible for the phone to always play the dial tone when the handset is off the hook, even when an active call is terminated, so that the user will know when/if a call is terminated.

Kind Regards
Dalton

[Lucia_Yealink]

Dear Dalton，

Yes，for your requirement, there is an option that can meet your requirement.

Please go to the web interface of the phone->Feature->General Information, find Busy Tone Delay (Seconds) option, change the value to 3 or 5, that means the phone will play the busy tone for 3S or 5S after the call terminated.

Any problem, please let me know.

Best Regards
Lucia

[Dalton]

(09-21-2017 07:17 AM)Lucia_Yealink Wrote:  Dear Dalton，

Yes，for your requirement, there is an option that can meet your requirement.

Please go to the web interface of the phone->Feature->General Information, find Busy Tone Delay (Seconds) option, change the value to 3 or 5, that means the phone will play the busy tone for 3S or 5S after the call terminated.

Any problem, please let me know.

Best Regards
Lucia

Thank you so much. This is exactly what I was looking for .